All door sizes shown in Cardale literature are the actual size of the opening that the door is to go into. Sizes shown are given as opening width x height in feet & inches. Therefore a 7066 door is made to fit an opening 7ft wide by 6ft 6 inches high. Similarly a 1470 door is made to fit an opening 14ft wide by 7ft high. Cardale generally build a tolerance of approximately 19mm into the width and 25mm into the height of the door panel supplied, this leaves a gap around the edges of the panel to allow for the unhindered operation of the door gear.
Yes, provided it is fitted firmly, is in good condition (no rot – especially at the bottom), fitted squarely in the opening and is a minimum of 70 x 70mm. If all of these conditions are met then it should be satisfactory. An alternative is to replace it with a Cardale steel frame that comes pre-fitted on single doors or as a knock-down kit on double doors.
All door sizes shown in Cardale literature are the actual size of the opening that the door is to go into. Sizes shown are given as opening width x height in feet & inches. Therefore a 7066 door is made to fit an opening 7ft wide by 6ft 6 inches high. Similarly a 1470 door is made to fit an opening 14ft wide by 7ft high. Cardale generally build a tolerance of approximately 19mm into the width and 25mm into the height of the door panel supplied, this leaves a gap around the edges of the panel to allow for the unhindered operation of the door gear.
Please refer to the Cardale Technical Guide, this can be located in the downloads section of the Cardale website.
For complete sizing information please contact your local garage door specialist who will be able to advise the correct door size for your requirements. Alternatively you may wish to download the Cardale Price list which details all the sizes available in the Cardale Range. This can be found in the downloads section of the website.